1
Safety Instructions
Safety Marking Instructions
Please be sure to read the following important safety instructions carefully before using
the product.
Transport Instructions
It is recommended that you transport this product in its original packaging
or equivalent.
This marking alerts the user to some important information regarding
operation and maintenance. Please read this information carefully to avoid
incorrect operation.
This marking warns the user that the uninsulated voltage inside the body of
this product may be sufficient to cause electric shock. Therefore, any form
of contact with any part of the body poses a risk of electric shock.
This marking warns the user to be aware of high temperatures.
This marking reminds the user to avoid touching with hands.
Grounding Warning
This product must be grounded when in use.
NOTE: The model approval code and safety information for this product are shown
on the bottom and back of the product.
Replacing the batteries with the wrong model may result in an explosion
hazard. So, be sure to dispose of used batteries according to the instructions.
As with any bright light source, do not gaze into the direct beam ( RG2GC/T30117.5-2019).
This product meets the requirements of JFC 60825-1:2014 class 1 laser products.
For USA: Complies with 21 CFR 1040.10 and 1040.11 except for conformance as a
Risk Group 2 LIP as defined in IEC 62471-5:Ed. 1.0. For more information see Laser
Notice No. 57, dated May 8, 2019. This product contains class 4 lasers, which should
only be serviced by authorized and trained service personnel. It is prohibited to
disassemble and repair by yourself.
Class 1 laser products
To Next Page
Loading...
