12
GREASE DRIVE GEARS
CLEANING
THE ROLLS
The recommended lubricant is Castrol Molub-Alloy 777-1 or equivalent.
Apply grease to all drive
gears after every 40 hours of operation. If the machine is to be used in a damp environment, apply
a film of oil or grease to all unpainted metal surfaces to prevent rust.
Keeping the forming rolls clean is an important step toward efficient operation of your machine.
Lockformer’s GALV-OFF aerosol spray cleaner, will soften galvanized build up so that it flakes off
by itself. Daily use is recommended. GALV-OFF cleans and lubricates, as well as protects the
forming rolls.
MAINTENANCE
To Next Page
Loading...