WARNING
THIS EQUIPMENT IS DESIGNED TO BE OPERATED WITH ALL
COVERS SECURED IN PLACE. OPERATION WITHOUT THESE
SAFEGUARDS MAY RESULT IN CONDITIONS WHICH ARE
HAZARDOUS TO THE OPERATOR AND OBSERVERS.
01
SAFETY GUIDELINES
Before operating the machine, study and follow the safety precautions in this section.
These precautions are intended to prevent injury to you and your fellow workers. They
cannot, however, cover all possible situations. Therefore, EXERCISE EXTREME
CAUTION and use COMMON SENSE before performing any procedure or operation.
Safety Precautions BEFORE Starting The Machine(s)
Only one person should control the machine(s). Never allow anyone to operate the controls while
you are operating or working on this equipment. In addition to disconnecting power always use
lock outs and tagouts to prevent accidental start-up when performing maintenance procedures.
Keep your hands away from internal workings of the machinery when starting, running or
stopping.
Keep your work area clean. Remove all scrap, oil spills, rags, tools and other loose items that
could cause you to slip, trip and fall.
When cleaning the machine or any of its components, do not use toxic or flamable substances.
Do not perform any cleaning while the equipment is running.
Never override or disable any safety switch or safety interlock.
If so equipped, make sure that hydraulic and pneumatic pressures are at specified levels before
operating this equipment.
Do not operate the rollformer unless all covers and guards are in place.
Be sure that this Instruction Manual is kept near the machine so the operator can refer to it when
necessary.
Keep this equipment properly maintained.
Always turn off power to the machine(s) at the main disconnect before performing any
maintenance or adjustments so accidental start-up or electrocution cannot occur.
To Next Page
Loading...