Need help?Do you have a question about the FORMTEK Lockformer LK-20 and is the answer not in the manual?
Essential safety rules and precautions for machine operation.
Precautions to take before operating the machine to prevent injury.
Precautions to take during machine operation to ensure safety.
General safety considerations for machine use and maintenance.
Details the warranty terms and conditions for the product.
Important caution regarding illustrations showing removed covers.
Emphasizes the importance of common sense and extreme care.
Record for personnel to confirm understanding of safety practices.
Information regarding the machine's noise levels.
Requirements for the machine's electrical power supply.
Specifies material thickness and types the machine handles.
Fundamental steps for operating the machine.
Procedure for adjusting hold down nuts on the female Pittsburgh lock.
Settings and adjustments for auxiliary roll hold down nuts.
How to adjust the entrance gauge for hammer-over edge width.
Instructions for the exit gauge.
Information about the opening roll.
How to install and operate auxiliary rolls.
Procedure for installing specific types of rolls.
Procedure for installing drive cleat rolls.
Recommended lubricant and frequency for drive gears.
Recommended cleaner and procedure for cleaning forming rolls.
Troubleshooting steps for incorrectly formed edges.
Addressing issues with material drifting or uneven edges.
Adjusting the unit for different material gauges.
Procedure for creating a starting flange for the attachment.
Steps for installing and operating the AGF attachment.
Diagram of the machine's chassis and associated parts.
Diagram showing the opening roll and related components.
Diagram of the hold down mechanism and parts.
Diagram of the straightener roll and associated parts.
Diagram of the top pulley assembly.
Diagram of the exit gauge assembly.
Diagram of the motor control components.
Diagram of the motor and pulley system.
Diagram of parts for the AGF attachment.
Diagram of additional parts for the AGF attachment.
Diagram of the center spacer component.
General| Brand | FORMTEK |
|---|---|
| Model | Lockformer LK-20 |
| Category | Industrial Equipment |
| Language | English |
To Next Page