02
Safety Precautions WHILE
Operating The Machine(s)
Never leave the work area while the equipment is in operation.
Never leave the machine unattended while it is under power or in operation.
Always be alert while operating machinery.
Be alert for loose, worn or broken parts. Do not attempt to operate any machinery with such parts
present or if the machinery is making unusual noises or actions.
Avoid skin contact, prolonged breathing, or eye exposure to any stock lubrication fluid being
used.
Be aware of the locations of the Power Off or Emergency Stop button in case of an emergency.
Be sure all guards and covers are in place.
Continually observe the rollforming process and related equipment. If any unusual condition
develops, immediately stop and inspect the machine.
Protect yourself ! Wear safety glasses. Do not wear loose clothing, neckties, or jewelry. If long
sleeves must be worn, avoid loose cuffs and buttons. Tie back and contain long hair.
Never adjust any roll feature or perform work near the rolls, gears or power take off while they are
running.
General
If any pneumatic or hydraulic feature is used, disconnect the main supply and exhaust pressure
and bleed the lines to prevent cycling on retained pressure.
Always shut off the power at the main disconnect switch before entering the electrical control
box.
Do not use compressed air to clean the machines. Air pressure may drive dirt and small chips
into the machine(s) bearing surfaces or cause bodily injury.
The information contained herein is to be use as a general guide only.
For further safey information obtain and read the ANSI bulletin entitled:
ANSI B11.12-1996 Rollforming and Roll-Bending Machines safety
Requirements for Construction, Care and Use.
CONTACT: American National Standards Institute
11 West 42nd Street
New York, New York 10036
IMPORTANT
To Next Page
Loading...