14
require exit gauge pressure along the materials edge such as long heavy pieces where an awkward
weight and size make it difficult for the operator to hold the piece straight during the forming
process. This technique must be used carefully. Other conditions may be causing the runnout,
such as loose settings on the hold downs or improperly adjusted entrance gauges (those settings
should always be checked first).
Having the exit gauge bar push too hard against the material might make the situation worse. The
operator must run test pieces and inspect the formed product to determine the best adjustment
position of the exit gauge bar.
FOLLOW ALL SAFTEY PRECAUTIONS IN THE MANUAL WHEN MAKING ADJUSTMENTS
!
To Next Page
Loading...