Cautions and Warnings
Environmental specifications
Refer to specific Product Model Data Sheet for Environmental Specifications (Operating
Temperature, Storage Temperature, Humidity, and Altitude).
Référez à la Fiche Technique de ce produit pour les caractéristiques environnementales
(Température de fonctionnement, température de stockage, humidité et l’altitude).
Safety
Caution: This equipment is to be used in a Network Environment 0 per IECTR 62101. This
product is connected only to PoE networks without routing to the outside plant.
Attention : Ce matériel doit être utilisé dans un Environnement Réseau 0 par IECTR 62101. Ce
produit est uniquement connecté aux réseaux PoE sans installation externe de routage.
This product is intended to be supplied by a Listed Direct Plug-In Power Unit marked LPS or
Class 2 and rated 5 Vdc, 2 A or by 48 Vdc from PoE source.
Le produit doit être alimenté par un bloc d’alimentation à courant continu homologué UL de 5
Vdc, 2 A nominal marqué LPS ou Class 2 ou par une source d’alimentation par Ethernet de 48
Vdc (PoE).
This product should be mounted at a height of less than 2 meters.
Ce produit doit être monté à une hauteur de moins de 2 mètres.
E911 and use with multi-line telephone systems
Please note the use and operation of this phone as part of a multi-line telephone system
(MLTS) may be subject to state and/or federal E911 MLTS laws that require the MLTS to
provide a caller’s telephone number, extension, and physical location to applicable state and/
or local emergency services when a caller initiates a 911 call. The MLTS may not provide a
caller’s telephone number, extension, or physical location information to emergency services
when a caller dials 911, and compliance with state and/or federal E911 MLTS laws is the sole
responsibility of the purchaser of this phone.
Privacy
This phone implements security and encryption technologies. However, privacy of
communications may not be ensured when using this telephone.
Regulatory Notices
Federal Communication Commission (FCC) – USA
This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received; including interference that may cause
undesired operation.
12
To Next Page
Loading...
