Fortinet FortiSIEM 2000G - Page 12

Appliance Setup
Option Description
--host Host name
-f FQDN address: fully-qualified domain name
-t
The IP type. The values can be either
4
(for
ipv4
)
or
6
(for
v6
)
or 64 (for both ipv4 and ipv6)
.
--dns1, --dns2 Addresses of the DNS servers
--i6 IPv6-formatted address
--m6 IPv6 prefix
--g6 IPv6 gateway
-o
Installation option (install_without_fips,
install_with_fips, enable_fips, disable_fips,
change_network_config*)
*Option only available after installation.
-z
Time zone. Possible values are
US/Pacific
,
Asia/Shanghai
,
Europe/London
, or
Africa/Tunis
--testpinghost The host used to test connectivity
16.
It will take some time to complete the FortiSIEMinstallation. If the installation is successful, then the VM will
reboot automatically. Otherwise, the VM will stop at the failed task.
You can inspect the ansible.log file located at /usr/local/fresh-install/logs if you encounter any
issues during FortiSIEM installation.
After installation completes, ensure that the phMonitor is up and running, for example:
# phstatus
For the Supervisor, Worker and Collector, the response should be similar to the following.
FortiSIEM 6.6.2 2000G Hardware Configuration Guide 12
Fortinet Inc.