Fortinet FortiSIEM 2000G - Page 11

Appliance Setup
14.
Test network connectivity by entering a host name that can be resolved by your DNS Server (entered in the previous
step) and responds to ping. The host can either be an internal host or a public domain host like google.com. In
order for the migration to complete, the system still needs https connectivity to FortiSIEM OS update servers: os-
pkgs-cdn.fortisiem.fortinet.com and os-pkgs-c8.fortisiem.fortinet.com. Press Next.
Note: By default, “google.com” is shown for the connectivity test, but if configuring IPv6, you must enter an
accessible internally approved IPv6 DNS server, for example: “ipv6-dns.fortinet.com"
Note:When configuring both IPv4 and IPv6, only testing connectivity for the IPv6 DNSis required because the
IPV6 takes higher precedence. So update the host field with an approved IPv6 DNSserver.
15.
The final configuration confirmation is displayed. Verify that the parameters are correct. If they are not, then press
Back to return to previous dialog boxes to correct any errors. If everything is OK, then press Run.
The options are described in the following table.
Option Description
-r The FortiSIEM component being configured
-z The time zone being configured
-i IPv4-formatted address
-m Address of the subnet mask
-g Address of the gateway server used
FortiSIEM 6.6.2 2000G Hardware Configuration Guide 11
Fortinet Inc.