Appliance Setup
5. Go to ADMIN > Health > Collector Health for the status.
Service Provider Deployments
For Service Provider deployments, follow these steps.
1.
Log in to Supervisor with 'Admin' privileges.
2. Go to ADMIN > Settings > System >Event Worker.
a.
Enter the IP of the Worker node. If a Supervisor node is only used, then enter the IP of the Supervisor node.
Multiple IP addresses can be entered on separate lines. In this case, the Collectors will load balance the
upload of events to the listed Event Workers.
Note: Rather than using IP addresses, a DNS name is recommended. The reasoning is, should the IP
addressing change, it becomes a matter of updating the DNS rather than modifying the Event Worker IP
addresses in FortiSIEM.
b. Click OK.
c.
FortiSIEM 6.6.2 2000G Hardware Configuration Guide 21
Fortinet Inc.
To Next Page
Loading...
