Fortinet FortiSwitch-28C - Power over Ethernet; Enabling PoE on a Port; Determining the PoE Power Capacity; Reset the PoE Power on a Port

Page 20
Power over Ethernet
This chapter contains information on using Power over Ethernet (PoE) with your FortiSwitch.
Power over Ethernet is only available on the following models: FortiSwitch-108D-POE,
FortiSwitch-124D-POE, FortiSwitch-224D-POE, and FortiSwitch-324B-POE.
Enabling PoE on a Port
config switch physical-port
edit <port>
set poe-status enable
end
end
Determining the PoE Power Capacity
To determine the PoE power capacity, use the following command:
get switch poe inline
Reset the PoE Power on a Port
To reset the PoE power on a port, use the following command:
execute poe-reset <port>