Fortinet FortiSwitchRugged 112D-POE - Installation

6 7
Using the provided hardware, the device can be mounted on a DIN rail or to a wall. Note
that M3 x 5mm have been provided for the DIN rail, but you will need to supply your own
wall mount and anchors screws.
To mount the device on a DIN rail
1. Connect the DIN rail bracket to the device using the provided bracket screws.
2. Position the device directly in front of the DIN rail, ensuring that the top of the DIN rail
bracket hooks over the top of the DIN rail.
3. Rotate the device until the bottom of the DIN rail bracket sits against the bottom of
the DIN rail.
You can now proceed with connecting your device.
Installation
1
DIN Rail
Bracket
FortiSwitch
DIN Rail
Bracket
DIN Rail
FortiSwitch
DIN Rail
Bracket
DIN Rail
FortiSwitch
To mount the device to a wall
1. Connect the wall mount brackets to the device using all of the provided brackets
screws.
2. Hold the device with the attached wall mount brackets against the wall in the desired
mounting location and mark the locations for the two anchors.
3. Using an appropriate drill, insert the mounting anchors into the wall at the marked
locations.
4. Screw the device into the anchors, then slide it downwards to secure it in place.
You can now proceed with connecting your device.
Wall Mount
Brackets
FortiSwitch
Wall Mount
Brackets
197.98mm
Note: This equipment is not suitable for use in locations where children are likely to
be present.