should keep High; Or in Write Mode,switch SW2 and SW3 to High, then enter
Verify Mode
Power on,enter the CRC Verify Mode
Put the IC of FU68xx series into Socket,and make sure it is in good contact
Observe the device doing task status on the LCD panel
Chart 1-3-3
1.3.4 Erase Mode
Erase steps：
Before power on again,make sure SW1 and SW3 both are switched to Low,but
SW2 should keep High; Or in Write Mode,switch SW2 to Low, and switch SW3
to High, then enter Erase Mode
Power on,enter Erase Mode
Put the IC of FU68xx series into Socket,and make sure it is in good contact
Observe the device doing task status on the LCD panel
Chart 1-3-4
Rev_V1.8 12 / 20 www.fortiortech.com
To Next Page
Loading...