1.3 Operation Introduction
1.3.1 Power on again
User may switch to the offline write mode after they have finished task of online
download, the detailed steps are shown as the below:
first plug out USB data line to make device power off
then make the switch to Offline on the left of the Writer (refer to chapter
1.2.3)
then re-connect USB data line to the write hardware board, and power on the
device again via USB.
According to the above three steps, device will enter the offline write mode, the
boot screen is shown as the below:
Chart 1-3-1
1.3.2 Offline Write Mode
Offline write steps:
Before power on agagin, make sure both SW1 and SW2 are switched to Low, but
SW3 should keep High
Power on, entry into the Offline Write mode
Put the IC of FU68xx series into Socket, and make sure it is in good contact
Press the yellow or Blue key on the board, and the device will execute the
corresponding action
Rev_V1.8 9 / 20 www.fortiortech.com
To Next Page
Loading...