Fortior Tech FU68 Series - Page 20

Fail status:
Chart
3-2-3
The detail of pin is shown as below:
Table 3-2
Pin Name
Direction
Description
Connection Module
VDD
Output
5.5V operating Voltage
SOCKET
FCK
Inout
Communication port, Connect to FICK pin at IC
SOCKET
FCD
Inout
Communication port, Connect to FICD pin at IC
SOCKET
GND
Earth ware
SOCKET
、
MACHINE
RUN
Input
Start sign; 3.3V port; Start writing/verifing/erasing
if signal change from 0 to 1, and machine exports
high level (3.3V) pulse last about 10 us; Suggest
the width of high level pulse is between 1~100ms.
MACHINE
S1
Output
Fail sign; 3.3V port; After start writing, S1 is low
until write fail, and at the same time the light
turned red
MACHINE
S2
Output
Success sign; 3.3V port; After start writing, S2 is
low until write success, and at the same time the
light turned green
MACHINE
Rev_V1.8 20 / 20 www.fortiortech.com