Fortis FSEFBTM520A - Troubleshooting

Code
Description
Solution
E01
Poor Communication
between Speed Sensors
and Control Console
Inspect connections between speed sensors and
control console.
If there is no display, contact Kogan.com to
replace it.
If there is no signal from the control console,
contact Kogan.com to replace it.
E02
Short Circuit
If there is open circuit in the treadmill motor, cease
use immediately and contact Kogan.com
If there is a poor contact with the motor, check the
connection.
If the power cable is damaged, cease use
immediately and contact Kogan.com
E03
Speed Sensor Failure
If the speed sensor is not in correct position, adjust
its position.
If the speed sensor is damaged, contact
Kogan.com to replace it.
E04
Overvoltage
Ensure the power supply match the treadmill’s
rated power.
Contact Kogan.com to replace motor or speed
sensor.
Contact Kogan.com to replace control console.
E05
Overcurrent Protection
Ensure the resistance of the running deck is not too
high. If it is, lubricate the treadmill.
See the Cleaning & Care section of this user guide.
If the motor is damaged. Contact Kogan.com
E06
Diagnostic Testing Error
Contact Kogan.com to replace control console.
E07 or ---
Safety Tether is in
Incorrect Position
Ensure to connect the safety tether to the control
console.
Safety Lock System Error
Contact Kogan.com to replace control console.
TROUBLESHOOTING