Foscam B4 - FAQ and Troubleshooting; Remote Connection Issues; Camera Added by Others Resolution

42
6 FAQ
6.1 Unable to connect camera remotely using Foscam app
Foscam P2P cameras allow users to connect camera remotely using Foscam app without extract setup
like port forwarding. When it unable to connect remotely, below tips can help app establish the
connection:
(1) Update app and camera’s firmware to latest version,
(2) Power off the camera then power back on,
(3) Delete camera from app then re-add it back, also lower camera’s resolution.
6.2 Camera is added by others
When using the Foscam application, a camera can only be added to one account at the same time. If
you encounter a prompt indicating that the addition failed, please reset your camera and try adding
again,If the reset camera still fails, please send a clear photo of camera’s model sticker to Foscam
support email support@foscam.com to unbind it.
6.3 What are the recommended internet requirements for this
device
Requires a minimum upload speed of 1Mbps, but 2 Mbps is recommended for optimal performance.
7 Default Parameters
Default network Parameters
IP address: obtain dynamically
Subnet mask: obtain dynamically
Gateway: obtain dynamically
8 Specification
ITEMS
B4
Spotlight
Color Temperature
6500K
Image Sensor
Sensor Type
High Definition Color CMOS Sensor
Display Resolution
4.0Megapixels(2560*1440)
Min. Illumination
0 Lux (With IR Illuminator)
Lens
Lens Type
f:3mm;vF2.0
Angle of view
Diagonal: 113.5°, Horizontal:98°, Vertical: 51°
Video
Image Compression
H.264
Resolution
2K(2560*1440) 20fps,VGA(640 x 360)