Quick Installation Guide
Indoor HD IP Camera with P2P
V1.1
EQR00001
"Foscam" App download
Front panel
Rear panel
Network Light Description
O No Wi-Fi connection
Constant
Flash
Wired connection
Flashing every 0.2 seconds EZLink takes eect (default)
Flashing every 0.4 seconds WPS is connecting
Slow Flash every 1.0 second Wi-Fi connected
1 Hardware Introduction
Physical Description
Hardware Installation
Hardware Connection
Network Light Status:
Package Contents
IP Camera
CD-ROM
Quick Installation Guide Warranty Card
Mounting Bracket
Power Adapter
WPS/Reset
Micro SD Card Slot
Microphone
Infrared LED
Lens
LAN
Power
Network light
Power light
Antenna
Speaker
Install your camera on the ceiling or wall with the supplied
mounting bracket.
WPS
1. Install wireless antenna and position upright.
2. Turn on your wireless router.
3. Connect the power adapter to the camera.
Wi-Fi Antenna
Model: R2
Quick Installation Guide
Indoor HD IP Camera with P2P
"Foscam" App download
Model: R2
Security Warning
Foscam cameras and NVRs require good security
practices to safeguard your privacy. You should
regularly change your camera or NVR password
which is 8-10 numbers, letters, symbols combination.
You should update your camera or NVR regularly.
Make sure your camera or NVR has the latest
rmware installed for your specic model and better
experience.
Before you continue, please note:
Make sure your smartphone is located near the camera.
Do not use an ethernet cable to connect the camera
if you want to use a wireless connection. And the camera
will play voice prompts ”Ready for WiFi conguration” .
Make sure smartphone is connected to your wireless
router.
To Next Page
Need help?
General
Weight and Dimensions
