Foster XR2H - Disposal Requirements; Start-Up and Test Sequence; User Adjustments; Manual Defrost

Disposal Requirements
If not disposed of properly, these cabinets have components that can be harmful to the environment. All
cabinets must be disposed of by appropriately registered and licensed waste contractors, and in accordance
with naonal laws and regulaons.
Care should be taken to avoid prolonged contact with cold surfaces with unprotected body parts, Correct
PPE to be used at all me.
When moving the appliance appropriate gloves should be worn, and a relevant risk assessment carried out
English
Aer unpacking, clean and allow the cabinet to stand for 2 hours before turning on (cleaning direcons
supplied within this manual). Ensure the cabinet is situated away from both hot and cold air sources,
as this will aect its performance. Make sure that a minimum clearance of 150mm above the cabinet is
available for venlaon and eecve operaon. Connect the unit to a suitable mains power outlet and turn
the supply on. Do not plug or unplug the unit with wet hands.
Start-Up and Test Sequence
Cabinets & counters are supplied ready for operaon.
Aer connecng the unit to the mains the display will briey show a dash in the centre of the screen. This
will then show
Press and hold the buon for 3 seconds then release. (If pressed and held for 5 seconds then released
will start the ‘Test Sequence’).
To cancel the ‘Test Sequence’ press and release the buon during the test.
If not pressed the test will connue and when complete the controller will wait 1 minute, then resume
normal operaon.
User Adjustments
To Check Storage Temperature Set Point
Press the buon for at least half a second to display the set point. if set point is unable to be
changed, please refer to keypad security sengs.
Manual Defrost
To iniate a manual defrost press and hold the defrost buon for 2 seconds
2