To Next PageTo Next Page
Need help?Do you have a question about the Fostex D-108 and is the answer not in the manual?
General| Tracks | 8 |
|---|---|
| Sampling Rate | 44.1 kHz |
| Bit Depth | 16-bit |
| Type | Digital Audio Recorder |
| Tape Format | DAT |
Details the recorder's capabilities including non-destructive editing, preview function, and undo/redo.
Covers essential safety guidelines for operating the D-108, including power, liquids, and environment.
Provides step-by-step instructions for formatting an E-IDE hard disk.
Details the process for formatting a SCSI disk as the current drive.
Explains how to format a SCSI disk specifically for backup purposes.
Guides users through the process of creating and naming new programs.
Introduces the concept of punch in/out recording for replacing recorded parts.
Explains the automatic punch in/out function for re-recording specific sections.
Explains how to perform punch in/out recording using a foot switch.
Details how to connect and record digital audio from external devices.
Explains how to assign incoming digital signals to specific tracks.
Describes how to output digital audio from the D-108 to external devices.
Explains how to record digital and analog signals concurrently.
Guides on recalling, editing, and re-storing data in memory keys.
Explains how to recall, edit, and re-store existing data from the LOCATE key.
Covers methods for directly locating points like program start/end and memory keys.
Step-by-step guide to previewing the sound at stored locate points.
Explains how to adjust locate point positions while previewing the sound.
Details the differences and procedures for Copy & Paste and Move & Paste operations.
Explains the three methods for erasing data: specified part, to REC END, and program erase.
Explains how to synchronize the D-108 with MIDI sequencers using MIDI clock.
Details synchronization using MTC and MMC for computer control.
Instructions for saving data to external devices via DATA OUT connector.
Explains how to load data from external devices via DATA IN connector.
Guides on saving data to and loading data from SCSI hard disks.
Details the procedure for saving all programs on the disk.
Explains how to load data from SCSI disks, including removable ones.
Covers procedures for using a SCSI drive as the primary drive for save/load.
Assigns incoming digital signals (SPDIF, ADAT) to specific tracks for recording.
Sets up the outgoing digital signal type and tracks for external digital equipment.
Configures the D-108's operating clock (Internal or External Sync).
