11
Adjust the volume balance
Adjust the volume balance between the speakers using the VOLUME knob on the back
of the unit. If other speakers are equipped with a volume control function, utilise them
together.
1 Lower the volume of the player (digital audio player, etc.)
The higher volume than you expect may be produced. Lower the volume in advance.
• If your player is not equipped with a volume controller, lower the volume of the speakers.
2 Start playback of the player, and adjust the volume balance.
Adjust the volume so that the bass sound and treble sound are heard naturally.
Switch the phase
You can reverse the sound phase using the PHASE switch on the back of the unit.
When you use this unit with PM0.3 or PM0.1 (especially when installing them side by side),
you can leave the PHASE switch at the 180° position. However, depending on the set up
position, the sound may be heard naturally when you change the switch to 0°. Test both
positions and select the better one.
English
To Next Page
Loading...
General