Need help?Do you have a question about the Foundry Networks FastIron LS 648 and is the answer not in the manual?
Describes the guide's purpose, products, and scope.
Identifies the intended readers and required knowledge.
Explains typographical conventions used in the guide.
Provides contact information for technical support and warranty.
Details physical characteristics and port density of FLS models.
Lists front panel controls like Serial Management and Reset buttons.
Lists interface types supported by the devices, including copper and fiber.
Discusses rear panel slots for 10GbE modules and CX4 ports.
Explains the meaning of various LEDs for status indication.
Introduces information about integrated and optional power supplies.
Covers general, lifting, and power safety precautions for installation.
Guidelines for site selection, temperature, airflow, and cabling.
Steps for installing the device on a flat surface.
Precautions and steps for mounting the device in a rack.
Instructions for mounting the device on a wall using a bracket kit.
Overview, supported devices, and key features of the RPS.
Step-by-step instructions for connecting switches to the RPS.
Details the pin configuration and function for the RPS2-EIF connector.
Steps for installing slide-in modules into switch slots.
Process for inserting SFP transceivers into ports.
Steps to power on the system after physical installation.
Steps for connecting a PC/terminal via serial port for configuration.
Diagrams and table showing serial cable wiring configurations.
Procedure for securing CLI access by setting passwords.
Steps to regain super-user access if a password is lost.
Instructions for setting IP addresses and default gateways.
Details on UTP cabling for connecting to hubs and switches.
Steps for connecting devices using fiber optic ports.
Methods to verify network connection status using LEDs and commands.
How to display and adjust temperature warning/shutdown levels.
Command to check the management module's CPU utilization.
General recommendations for hardware upkeep.
Steps for installing or replacing 10GbE modules.
Steps for removing and installing fiber optic modules.
Instructions for cleaning fiber optic connectors to ensure performance.
Configuration and viewing of optical monitoring for XFP ports.
Guide to troubleshooting issues based on LED status.
Steps to diagnose and resolve power or cooling related issues.
Troubleshooting network connectivity for management access.
Overview of hardware specifications for the FastIron LS family.
Tables detailing the physical dimensions and weight of FLS624/FLS648.
Operating and storage environment specifications.
Details on the cooling system, airflow, and noise levels.
Lists EMC, Immunity, and Safety agency approvals.
Information on console and network port pin assignments.
Reference to tables detailing cable types and lengths.
Specifications for the integrated AC power supply.
Details on the optional RPS, including features and dimensions.
FCC Part 15 Class A compliance statement for US operation.
Canadian ICES-003 compliance statement.
General Class A product statement for interference.
VCCI Class A compliance statement for Japan.
General cautions regarding equipment handling, environment, and procedures.
General warnings about potential hazards, injury, or death.
General| Model | FastIron LS 648 |
|---|---|
| Ports | 48 |
| Uplink Ports | 4 |
| Power Supply | Internal |
| Jumbo Frame Support | Yes |
| Manageable | Yes |
| Power Supply Voltage | 100-240 VAC |
| Humidity | 10% to 90% non-condensing |
| MAC Address Table Size | 32K |
| Features | VLAN |
| Dimensions (W x D x H) | 17.3 x 16.5 x 1.7 in (44 x 42 x 4.3 cm) |
| Operating Temperature | 0 to 40°C (32 to 104°F) |
| Storage Temperature | -40 to 70 °C |
To Next Page
