35
It is possible to activate the sound alarm output (and also all the other alarm outputs described later) for 15 types of
alarms. One or more alarms can be activated as desired. To activate an alarm set the value from “0” to “1” in the
following table
For example, the mask “100110000000000” will activate the following alarms: V Min, V Max, Min Level e Max Level.
The XTREME¹ always shows to display each alarm detected, but it will activate the alarm output only if it’s configured
properly.
N.B.: The alarms “I Min, cos φ Min”, “I max”, ”Service Request”, “Max Starts per Minute/Hour”,
“Intervention Klixon”, “Water in Oil Chamber” e “Max Continuous Operation”, TO BE ACTIVATED, MUST BE
ASSOCIATED TO AT LEAST ONE PUMP; THERE MUST BE ACTIVE AT LEAST ONE OF THE “ALARMS PUMP”.
To go back to the horizontal menu press the button
. Back to the horizontal menu “Configuration Sound Alarm”:
Press the button
to move to the configuration of the next alarm output :
Configuration
Sound Alarm
Configuration
GSM Alarm
Configuration
Visual Alarm
Configuration
Visual Alarm
Configuration
Sound Alarm
Configuration
Relay 1
The vertical parameter “Configuration Sound Alarm” will set the operating mode of the visual
alarm output on GSM card (therefore, GSM option must be present). It is an output voltage 12
Vcc, max 30 mA) with faston connector (see page 41). This is set-up to be connected to a
flashing alarm but it could be used for any other device with the following electrical
characteristics: 12 Vcc, 30 mA max.
Factory default setting: 100111111100110.
Configuration
Visual Alarm
NOTE: the alarms in gray are automatically sent only if is mounted GSM modem.
There is no need any configuration and it's not possible to disable these features.
1
not be disabled
111
0
(only whit GSM modem) Absence/Return mains
(only whit GSM modem) Black-out Max level
(only whit GSM modem) Low battery
11
0000
Max start per minute, Max start per hour
Max Klixon interventions
Detection of water in oil chamber
Max continous working
11
00
V Min, V Max
Phase Seq., Min Hz, Max Hz
4-20 mA device malfunction
Min level
00000
1111111
0
1
0
1
0
1
I max
Service
Max level
Pump 1 alarms
Pump 2 alarms
Pump 3 alarms
I Min, cosφ
Min
ALARM ON
ALARM OFF
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
To Next Page
Loading...
