3
UK
SENSITIVITY “+” AND “-“ BUTTONS
These buttons allow the user to adjust the
number of “beeps” that are required to
illuminate the light. Initially, the unit is set to
sensitivity level 8, which will result in the light
illuminating on a single “beep” from the
bite alarm.
Pressing the “sensitivity +” button will increase
the sensitivity setting. Each time the button is
pressed, the light will flash briefly, to indicate
the new setting, i.e. 1 flash = level 1, 2 flashes
= level 2, …. etc …. 8 flashes = level 8.
Pressing the “sensitivity -“ button will have the
reverse effect
.
DELAY “+” AND “-“ BUTTONS
These buttons allow the user to adjust the
length of time that the light remains on, after
it has received a transmission from a bite
alarm. There are 8 different delay
settings available, which are indicated by
flashes. The corresponding time delays are
as follows -
CONTROLS:
IMPORTANT NOTE:
Before using your Halo Elite for the first time,
you must “register” it with your bite alarms
and/or receiver. See page 8 for details.
The Halo Elite bivvy light incorporates 5 push
button controls, as follows -
ON/OFF SWITCH
Use this button to switch the Halo Elite on
and off. When first switched on, the light will
illuminate, for a period determined by the
current delay setting (see page 4) and will
then go out. It can be switched back on by
using the remote keyfob, or in response to a
transmission from a bite alarm.
ON/OFF
SENSITIVITY
TIME DELAY
To Next Page
Loading...