5
UK
Battery replacement
Replace the batteries in your Halo Elite,
when the brightness of the lamp has
reduced considerably. The exact point at
which batteries are replaced should be
determined by what is acceptable to the user.
The radio system will continue to
function long after the lamp brightness has
fallen to an unacceptable level, so this is not
a consideration.
Note: the Halo Elite has been designed for
use in a bivvy. Please do not expose it to rain
or moisture.
KEYFOB REMOTE CONTROL
The keyfob remote control
can be used to switch your
Halo Elite bivvy light on or off
at any time, as long as the
Bivvy light has not been switched
“OFF” from the ON/OFF switch.
Press and release the button on the keyfob
to operate.
IMPORTANT NOTE: always remember to
switch your bivvy light “OFF” at the ON/OFF
switch, at the end of a night fishing session.
The internal radio receiver in the bivvy light
will slowly drain the batteries, over a
period of weeks, even though the light is
not illuminated.
Battery - the Keyfob requires 1 x CR2032 3V
lithium coin cell (supplied). With normal usage,
this battery should have a very long life.
To fit/replace battery - insert a coin into
the battery cover at the rear of the keyfob
and rotate anticlockwise so that the cover
lifts off. Ensure battery is fitted with the “+”
face uppermost. Replace the cover and
rotate clockwise, so that the mark on the
cover aligns with the “locked” symbol.
Replace the battery, when the keyfob
becomes unreliable, or the operating range
reduces noticeably.
To Next Page
Loading...