4
UK
Level 1 = 10 seconds
2 = 30 seconds
3 = 1 minute
4 = 2 minutes
5 = 5 minutes
6 = 10 minutes
7 = 20 minutes
8 = 30 minutes
Initially, the unit will be set at delay level 1
(10 seconds). To increase the delay, press
and release the “delay +” button.
To decrease, press the “delay -“ button.
Each time a button is pressed, the light will
flash briefly, to indicate the new setting, i.e.
1 flash = level 1, 2 flashes = level 2, …. etc
…. 8 flashes = level 8.
Note that -
•The remote keyfob can still be used to
switch the light on or off at any time
•Delay setting does not apply if the light is
switched on using the keyfob - it will remain
on, until switched off by the user.
BATTERIES
TO FIT / REPLACE BATTERIES:
The battery compartment is located on the
base of the unit. Unclip the cover to access
the batteries.
Ensure batteries are inserted the correct
way round, as shown in the battery
compartment.
BATTERY REQUIREMENTS
The Halo Elite model requires 2 x 'C' size
(LR14) 1.5V alkaline batteries.
The use of good quality alkaline batteries is
essential for maximum battery life.
To reduce the risk of battery leakage, DO
NOT mix old and new batteries. DO NOT mix
different battery types. The use of
rechargeable batteries is not recommended.
As with any battery operated product, it is
recommended that the batteries be removed,
if the unit is not to be used for a long period
of time.
To Next Page
Loading...