6
UK
MAGNETIC MOUNTING SYSTEM
To attach the Halo Elite to your bivvy - remove
the metal plate from the back. Hold the Halo
Elite up to the inside of your bivvy, in the
desired location and place the metal plate on
the outside of the bivvy, so that the fabric of
the bivvy is sandwiched between the metal
plate and the base of the Halo Elite.
REGISTRATION PROCEDURES
One of these procedures must be followed,
before you use your Halo Elite for the first
time. They do NOT need to be repeated
again, unless you change, or add to, your bite
alarms or receiver. Registration data is held
in “non-volatile” memory and is retained
indefinitely, even if the batteries are removed.
Please read the following questions carefully,
to determine which procedure you should
follow -
DO YOU OWN AN I-COM INTERACTIVE
TRANSCEIVER? - if so, please go straight
to “PROCEDURE(4) - Registration with an
I-COM Transceiver”
DO YOU OWN AN RX3 RECEIVER OR
TXR+ SYSTEM? - if so, please go straight to
“PROCEDURE(3) - Registration with an RX3
receiver (including TXR+).”
DO YOU OWN ANY RADIO-EQUIPPED
BITE ALARMS (EOS-R, PSR, RS SERIES),
BUT DO NOT OWN A RECEIVER? - if so,
please go straight to “PROCEDURE(2) -
Registration without a receiver”.
DO YOU WISH TO USE THE UNIT WITH
THE KEYFOB ONLY? - i.e. you do not own
any other radio-equipped units - please follow
“PROCEDURE(1) - Registration as a
stand-alone unit.”
PROCEDURE(1)
Registration as a stand-alone unit
This procedure will allow you to use the Halo
Elite with its remote keyfob only. Should you
subsequently purchase any radio-equipped
bite alarms, you should repeat the
registration process, following one of the
other procedures below, depending on which
products you have purchased.
To Next Page
Loading...