MACHINE CLEANING
1. Open bandsaw doors (12) Fig.1.
Remove the saw dust using a dust collector or pincers:
- inside the lower part of the carter;
- inside blade guides;
- on the control elements.
2. Close bandsaw doors (12) Fig.1.
Do not use thinners to clean plastic parts. The majority of plastic materials risk to be damaged by thinners
available on the market. Use a clean cloth to remove waste, dust, etc.
- After any maintenance of cleaning operation, check that the all safety devices work correcly.
- Replace damaged pieces, in particular safety devices, with original spare parts, given that spare parts which
aren't checked and approved by the manufacturer can cause unforeseen damages.
- Any maintenance or repairing operation different from the ones described in this paragraph must be carried
out only by qualified personneI.
NDSAW ARRANGEMENT
WARNING:
KEEP THE MACHINE IN A SUITABLE WAY IN ORDER THAT:
- IT CAN'T BE SWITCHED ON BY UNAUTHORIZED PEOPLE;
- NOBODY CAN GET HURT WHEN THE MACHINE IS STILL.
WARNING:
DO NOT KEEP THE MACHINE OUTDOORS WITHOUT PROTECTION, OR IN A HUMID
PLACE.
To Next Page
Loading...
Need help?
General
