Fox FLOAT SL User Manual

7
REBOUND ADJUSTMENT
The rebound adjustment is dependent on the air pressure setting. For example, higher air pressures
require slower rebound settings. Use your air pressure to find your rebound setting.
Turn your rebound knob to the closed position (full clockwise) until it stops. Then back it out (counter-
clockwise) to the number of clicks shown in the table below.
REBOUND ADJUSTER
Air Pressure (psi/bar)
Starting Rebound
Setting
<100 / <6,9 10
100-120 / 6,9-8,3 10
120-140 / 8,3-9,7 9
140-160 / 9,7-11 8
160-180 / 11-12,4 7
180-200 / 12,4-13,8 6
200-220 / 13,8-15,2 5
220-240 / 15,2-16,5 4
240-260 / 16,5-17,9 3
260-280 / 17,9-19,3 2
280-300 / 19,3-20,7 1
Rebound controls the rate of
speed at which the shock
extends after compressing.
LEAST AMOUNT OF
REBOUND DAMPING,
SHOCK REBOUNDS
FASTEST
MOST AMOUNT OF
REBOUND DAMPING,
SHOCK REBOUNDS
SLOWEST
CLOSED
(CLOCKWISE)
OPEN
(COUNTER-CLOCKWISE)
9 8 7 6 5 4 3 2 1

Fox FLOAT SL Specifications

General

Type	Rear Shock
Remote	Optional
Spring	Air
Adjustments	2-position lever
Damper	FIT4 damper
Sizes	165x38 mm
Intended Use	Cross Country
Air Spring	FLOAT Air Spring