Chapter 2 Installation Instructions
12
Other Connectors
This motherboard includes connectors for FDD devices, IDE devices, Serial ATA
devices, USB devices, IR module, CPU fan, System fan and others.
FDD Connector: FLOPPY
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
IDE Connectors: PIDE & SIDE
The PIDE connector supports Ultra ATA 100/66/33 IDE hard disk drives. The
SIDE connector supports Ultra ATA 133/100/66 IDE hard disk drives. Connect
the cable’s blue connector to the IDE connector, then connect the gray connec-
tor to the slave device (hard disk drive) and the black connector to the Ultra
ATA master device.
Audio Connectors: CD_IN, AUX_IN (optional)
CD_IN and AUX_IN are Sony standard CDaudioconnectors,they can be con-
nected to a CD-ROM drive through a CD audio cable.
Fan Connectors: CPU_FAN, SYS_FAN
The fan speed can be detected and viewed in “PC Health Status” section of the
CMOS Setup. These fans will be automatically turned off after the system en-
ters S3, S4 and S5 mode.
SYS_FAN
SENSE
POWER
GND
1
CONTROL
CPU_FAN
SENSE
GROUND
1
POWERCONTROL
AUX_IN
1
AUX_R
GND
AUX_L
CD_IN
1
CD_L
GND
CD_R
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn
To Next Page
Loading...
