Foxconn 945P7MD - Page 36

Chapter 3 BIOS Description
29
vGate A20 Option
This option is used to set up the A20 signal control necessary for system is
started.
vSecurity Option
When it is set to “Setup”, a password is required to enter the CMOS Setup
screen; When it is set to “System”, a password is required not only to enter
CMOS Setup, but also to start up your PC.
vAPIC Mode
This option is used to enable or disable APIC function.
vMPS Version Control For OS
This option is used to set up the version of MPS Table used in OS.
vOS Select For DRAM > 64MB
This option is only required if you have installed more than 64 MB of memory
and you are running the OS/2 operating system.Otherwise,leave this item at
the default.
vDelay For HDD(secs)
This option is used to set the delay time of selecting the HDD controller.
vFull Screen LOGO Show
This option allows you to enable or disable the full screen logo. The available
setting values are: Disabled and Enabled.
vSmall Logo (EPA) Show
This item allows you to enable or disable the EPA logo.
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn