5
33
2. Select a RAID array for use (also can refer to section 5-3)
After rebooting your computer, you will see the RAID software prompting you to
press [F10].
Press [F10] to enter the NVIDIA MediaShield BIOS setup and congure the mirrored
RAID array as described in the 5-3 section. Finally, you can reach this step as
depicted.
3. Press [Ctrl]+[X] keys to exit and go to Windows.
4. In Windows, click "Cancel" to skip any "Found New Hardware Wizard".
Use driver CD and click on "NVIDIA MCP61 Chipset Driver" to install the NVIDIA
RAID driver. The RAID driver can be installed only when you select [Enable] in BIOS
"RAID Enable" setting. If you do not select [Enabled], then RAID driver can not be
installed.
MediaShield Utility Apr 26 2007
- Array List -
[Ctrl-X] Exit [↑↓] Select [B] Set Bootable [N] New Array [ENTER] Detail
Boot Status Vendor Array Model Name
No Healthy NVIDIA MIRROR 232.88G
To Next Page
Loading...
Need help?
General
