Mounting
Sky End Mounting
Install the sky end on the UAV and mount the antenna. Make sure the SMA
interface is tightened. The transmission quality will be the best when the antenna faces
down vertically without metal objects around it within 20 cm and avoid block caused by
the body.
1. Mount Antenna
2. Connect gimbal with the FC
Connect the gimbal with VDC-22 / VDC-55 via Ethernet interface and connect
the VDC-22 / VDC-55 to the FC by UART1 ( RS232 by default) and UART2 (TTL by
default). Please connect the SBUS_OUT interface on VDC-22 / VDC-55 to SBUS interface
on FC to realize RC control.
Note: If the gimbal is connected with HDMI/SDI/AV interface, a module should
be added first.
All of the signal line should try to away from wires of the motor or BEC, or
there may be interference.
VDC-22 / VDC-55 User Manual
©2022 FOXTECH All Rights Reserved 9
To Next Page
Loading...
Need help?
General