Installation and commissioning
23
Connecting the feeder
Caution! If the feeder was previously in a
cold environment (i.e. below 10 °C / 50 °F):
Wait at least 2 hours after unpacking before
connecting the feeder. The feeder needs this
time to adjust to the environmental conditions.
Connection on the franking machine • Connect the feeder connection cable to the
CAN-BUS interface of the franking
machine. Screw the connector on tightly.
Power connection • Plug the power cable into the power con-
nection for the feeder.
• Only then plug the power cable into the
power socket.
To Next Page
Loading...
