22
4 LAYOUTS & SWITCHES
STARTUP LAYOUTS
Each connected FC Controller has its own default layout which loads automatically
when you power on. You can change the default layout as follows.
SET DEFAULT LAYOUTS:
On the Axe-Fx III, open the “ page of the FC Controllers menu under SETUP.
Use the C knob or NAV buttons and VALUE wheel to set the desired default layout.
You can also manually change the current layout on any unit using this page.
The Devices page also allows you to set up Mirroring (see p.9).
NAMING LAYOUTS
Layout Names appear in the Master Layout Menu and can also appear on dedicated Layout footswitches.
Changing the name of any layout is simple with the same interface used to name presets and scenes.
NAME A LAYOUT:
On the Axe-Fx III, open the “ page of the FC Controllers menu under SETUP.
Use the A knob or NAV buttons to select the desired layout.
Push the EDIT NAME button (push-knob C).
Enter the desired name, up to ten characters:
Turn the B knob or use NAV buttons to move the cursor.
The C knob selects upper case letters.
The D knob selects lower case letters.
The E knob selects numbers.
The VALUE knob selects ALL characters, including symbols.
Press D or E for INSERT and DELETE functions.
Press ENTER to commit the name or EXIT to cancel.
Reminder: All changes in the FC Controllers menu take effect immediately with no need to store.
To Next Page
Loading...
