Need help?Do you have a question about the frako RM 2112 and is the answer not in the manual?
General| Rated operational voltage | 250 V AC |
|---|---|
| Rated operational current | 10 A |
| Contact configuration | 2 CO (DPDT) |
| Mechanical life | 10, 000, 000 operations |
| Electrical life | 100, 000 operations |
| Coil voltage | 12V DC |
Details on mounting the reactive power control relay in a control panel space.
Instructions for connecting the voltage supply to the control relay terminals L and N.
Guidance on connecting the current transformer outputs to the control relay terminals S1 and S2.
Connection diagram and explanation for a single-phase connection setup of the control relay.
Describes a precise measuring procedure for overcurrent using the 'Meas' terminal.
Diagram showing how to connect the control relay with a control transformer for power supply.
Guidance for connections when phase conductors do not exceed 240 V AC, covering 'Meas' terminal usage.
Steps for the initial start-up, including connection type and stage size determination.
Setting the desired target power factor for the reactive power control relay.
Detailed explanation of setting the target power factor and its control characteristic.
How the relay operates in automatic mode, measuring and controlling power factor.
Identification of connection errors after initial start-up or check system procedure.
Addresses issues where the control relay is not functioning or showing any displays on the front panel.
Troubleshooting when the relay ignores manual switching commands despite power and indicators being active.
Diagnosing why capacitor contactors are not activated even when the stage indicator is lit.
Resolving issues where the automatic measuring procedure fails to complete or terminate.
Addressing the issue of a stage being continuously activated and deactivated in automatic mode.
Diagnosing why no stages activate in automatic mode when the load is inductive.
To Next Page
