11
Fan speed button
• Control the fan speed. Press to select fan speed in three steps-low, med and high. The fan speed
indicator light illuminates under different fan speed settings.
• Press and hold the Fan speed button for 3 seconds to eliminate filter reminder, when the filter light
flickers (on some models).
Note: The unit operates for 250 hours, then enter filter clean reminder.
Wireless button
• Press and hold on the POWER button for 3 seconds to initiate the Wireless connection mode. The
LED DISPLAY shows „AP” to indicate you can set Wireless connection.
• If connection (router) is successful within 8 minutes, the unit will exit Wireless connection mode
automatically and the Wireless indicator illuminates and the unit enters the previous function. If
connection is failure within 8 minutes, the unit exits the Wireless connection mode automatically.
Note: When the unit is connecting to internet, the quick glance light will flash white light.
Fresh button
Press FRESH buttons to initiate FRESH feature, and the fresh indicator light illuminates (The fresh indicator
light and the UV indicator light illuminate at the same time on some models; Only the UV indicator light
illuminate on some models).The ion generators energized and UV (UltraViolet) feature will help to purify the
air inside. Press FRESH buttons again to stop FRESH feature, and the fresh indicator light turns dark.
Lock feature
• Press and hold on the Up (+) and Down (-) buttons for 3 seconds to initiate LOCK feature and the Lock
indicator light illuminates. All current settings are locked, and the control panel will not accept any
operation except of the LOCK.
• Press and hold these two buttons button again to cancel the LOCK feature.
Quick glance light button
• Press buttons to illuminate the quick glance light or turn quick glance light dark.
• When the humidity is more than 65%, the quick glance light will emit red light.
• When the humidity range is at 45% to 65%, the quick glance light will emit green light.
• When the humidity is lower than 45%, the quick glance light will emit yellow light.
Note: When bucket full or clean filter is on, the quick glance light will emit orange light and turn off 1 sec
every 4 sec.
Display
Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while setting, then shows the
actual (±5% accuracy) room % humidity level in a range of 30% RH(Relative Humidity) to 90% RH (Relative
Humidity).
To Next Page
Loading...