16
• Insert the water hose into the unit from the drain outlet in the back of the unit.
• Attach the water hose to the drain hose outlet of the unit.
• Make sure the connection of the water hose and the drain hose outlet of the unit is tight and do not
let the water leak.
• Then lead the water hose to the floor drain or a suitable drainage facility.The drainage facility should
be lower than the drain outlet of the unit. Be sure to run the water hose sloping downward and let
the water to flow out smoothly. Do not install the water hose.
• Make sure the water hose is lower than the drain hose outlet.
Note:
• When the continuous drain feature is not being used, remove the drain hose from the outlet.
• Use needle nose pliers if the plastic panel is too difficult to remove by hand.
• Burrs may hurt hand while connecting the drain hose. Please using a reamer or a deburring tool to
remove all burrs from the cut section of the panel.
Turn the dehumidifier off and remove the plug from the wall outlet before cleaning.
Clean the grille and case
• Use water and a mild detergent. Do not use bleach or abrasives.
• Do not splash water directly onto the main unit. Doing so may cause an electrical shock, cause the
insulation to deteriorate, or cause the unit to rust.
• The air intake and outlet grilles get soiled easily, so use a vacuum attachment or brush to clean.
To Next Page
Loading...