Customer Service: 1800-914-9835 | support@frameitall.com
JOINING MULIPLE ANIMAL BARRIER KITS
Stacking kits to make a higher barrier – Assemble the kit for the upper level in the same way as for
the lower level except, before installing the gate assemblies, slide a round sleeve, (Part 22) onto the
corner post of the gate, below the gate hinges.
NOTE: Each Animal Barrier kit contains one Part 22, which is not needed unless stacking kits.
Slide the round sleeve
(22) below the short
sleeve.
Slide the round
sleeve (22)
below the hinge
connector
EXPANDING BARRIER AREA WITH MULITPLE KITS - EXTENSION OPTION 1: PLACING GATES PLACED IN
DIFFERENT AREAS OF THE GARDEN BED
Customer Service: 1800-914-9835 | support@frameitall.com
To extend your animal barrier
with additional kits, simply
connect them in a loop using
additional vertical poles (Part 20)
and Horizontal Poles (Part 19)
connected with Part 1 & 2 as
shown.
To Next Page
Loading...
