What to do if my Franke 2DBR-18 Refrigerator does not run?
If your Franke Refrigerator isn't running, first ensure the rocker switch is in the ON position. Also, check if the electronic controller has been turned off; if so, push and hold the power button (located in the top-right corner of the controller) for 5-7 seconds. Finally, inspect the circuit breaker and reset it if it has tripped.
Why is the product in drawers of Franke 2DBR-18 Refrigerator above the target temperature?
If the product in the drawers of your Franke Refrigerator is above the target temperature, it could be due to a high ambient temperature in the store. In this case, you should decrease the set point temperature of the controller. Also, make sure that the food has been pre-chilled before placing it in the drawers; otherwise, place the product into cold storage until its temperature is within food safety limits.
What to do if Franke 2DBR-18 Refrigerator is running, but does not reach target operating temperatures?
If your Franke Refrigerator is running but not reaching the target operating temperatures, it could be due to a high ambient temperature in the store, decrease the set point temperature of the controller. Alternatively, the condenser coil might be dirty or clogged; in that case, use a soft bristle brush to clean the coils.
Why is frost building up on openings around drawers of Franke Refrigerator?
If you notice frost building up on the openings around the drawers of your Franke Refrigerator, it's likely that the door gaskets are either damaged or not installed correctly. Check the drawer gaskets to ensure they are correctly installed and free from cracks or damage.
Why product in drawers freezes in Franke 2DBR-18 Refrigerator?
If the product in the drawers of your Franke Refrigerator freezes, the set point temperature of the controller might be too low. Increase the set point temperature of the controller.
Emphasizes the importance of keeping and referring to the safety guidelines provided.
Provides a general description of the 2-drawer refrigerator's features and intended use.
Step-by-step instructions for physically placing and preparing the unit for operation.
Details the location and function of the main power switch for the unit.
Specifies the default temperature settings and the permissible adjustment range.
Instructions on how to modify the refrigerator's internal temperature.
Describes the steps to turn on and prepare the refrigerator for storing products.
Outlines the process for shutting down and performing routine cleaning.
Instructions for safely removing the drawers from the refrigerator unit.
Procedures for correctly reinstalling the drawers into the refrigerator.
General| Brand | Franke |
|---|---|
| Model | 2DBR-18 |
| Category | Refrigerator |
| Language | English |
To Next Page