-19010500- • Rev. B • June 11, 2018
4
INSTALLATION
Installing the Refrigerator
1. Remove any packaging from the outside and
inside of the unit.
2. Remove any protective film covering the
stainless steel surfaces of the refrigerator and its
accesories.
3. Remove drawers (Fig. 2) (See
Drawer Removal
,
page 6) and inspect to ensure fans and air return
holes are clear (Fig. 3).
Fig. 2
Fig. 3
4. Wipe down all interior surfaces of the unit and
drawers before loading.
5. Reinstall both drawers (Fig. 4) (See
Drawer
Installation
, page 7).
Fig. 4
6. Ensure that there is 2" of clearance between the
refrigerator and any nearby equipment to either
side.
7. Plug the refrigerator into the proper electrical
receptacle, per data plate specifications.
8. Set the refrigerator into position and lock casters
in place (Fig. 5).
Fig. 5
UNLOCKLOCK
9. Open the top drawer and toggle the power switch
ON to start the refrigerator (Fig. 6). Close the
drawer once powered ON.
Fig. 6
SWITCH
GUARD
POWER
SWITCH
To Next Page
Loading...
Need help?
General
