BBR Operating Manual Page 7
§ Wipe down, sanitize and dry the refrigerator interior.
§ Wipe down, sanitize and dry individual shelf components if pre-
installed.
5 Determine Refrigerator Wall Mounting Location
§ Identify wall-mounting
location [typically] within the
drive-through area. The BBR is
typically mounted
immediately right or left of the
pass-through window, on the
adjacent wall, and above the
beverage/POS counter and
within easy reach of the drive-
through crewmember. See
diagram at right.
Figure 1
Case Mounting Location
6 Electrical Preparation
§ Before you wall mount this unit, locate the
appropriate 120-volt power outlet, per the
rough-in drawing (Figure 2). This may be a wall
mounted outlet or one provided on the optional
vertical electric chase. (See Figure 1, previous
page)
§ A six-foot power cord with grounded plug is
provided with the BBR. This cord will be
shipped inside the left side [sloped and vented]
access panel. Two power cord holes with
protective edge guards are provided, one on the
WARNING Wall preparation must be done by qualified carpenters
and/or equipment installers capable of evaluating wall
construction and securely wall mounting a heavy refrigerated case.
Wall anchor failure could cause serious injuries or even death.
To Next Page
Loading...
