Franke BBR Series - Page 9

BBR Operating Manual Page 9
engage the full width of the refrigerator case top-rear frame/flange.
§ Locate center point of desired case-mounting position on wall
surface. Measure up 82 from floor for BBR-36 Model or 80 for
BBR-45 Model, which will provide a BBR unit bottom height or
clearance of 57 .
§ Place the bottom of mounting strip at the measured height against
wall, on center with your mark. Level the mounting strip with a small
spirit or laser level. Mark location of the six
[minimum] screw holes in the mounting strip. [See Fig. 4]
Figure 4 Case Bottom Height Figure 5 Mounting Strip Height
§ Drill six [minimum] pilot holes in the anchor wall.
§ Secure mounting strip to wall using #12 x 2" long [minimum] wood
screws. Make sure top edge of strip protrudes from wall, so flange
on case can slip behind strip. Recheck level of mounting strip.
§ Get help and lift unit from sides. Lift it up to height that will clear
mounting strip with top/rear frame flange on cabinet then slowly
lower case flush with wall, to engage mounting strip along full
length. Ensure refrigerator frame flange slips behind the mounting
strip, while you continue to supporting weight of cabinet. NOTE:
Make sure power cord isn!t trapped or pinched behind unit during
this wall hanging process.