EasyManuals Logo

Franke Crystal User Manual

Franke Crystal
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
– 11 –
FMW 45 CR C XS / FMW 45 CR C BK
EN
INSTALLATION
Unpacking
When you receive the appliance, unpack it
or have it unpacked immediately.
Check its general appearance.
Make a note of any reservations on the
delivery slip and keep a copy.
Remove all protective packing.
Check and follow the appliance’s
specifications which are listed on the
data plate.
Nr
SERVICE:
TYPE:
CC
XXXXXXXXX
XXXXXXXXX
XXXX
XXXXX
XXXXXXXXX
XXXXXXXXX
XXXXX XXX
XXXXX
XX XX XXXX
Choice of location and fitting
This appliance can be installed in a cabinet
column as shown in the images below.
550
>=550
<=70
560
450
>=460
550
>=550
<=70
560
450
>=460
550
>=550
<=70
560
450
>=460
Do not use your appliance immediately (wait
approximately 1 to 2 hours) after transferring
it from a cold place to a warm place, as
condensation may cause a malfunction.
Centre the oven in the cabinet so as to ensure
a minimum distance of 10 mm between the
appliance and the surrounding unit.
The material of the cabinet supporting
the appliance must be heat resistant (or
covered with a heat-resistant material).
For greater stability, attach the oven to
the unit with 2 screws through the holes
provided on the side panels.
Electrical connection
Installation should only be performed
by installers and qualified technicians.
The appliance must be recess-fitted
correctly to ensure electrical safety.
The electrical connections should be made
before the appliance is installed in its
housing.
Ensure that the circuit has sufficient power
(16 Amps).
The safety wire (green-yellow) is connected
to the appliance’s ground terminal and
must be connected to the installation’s
earth.
If the oven malfunctions in any way, unplug
it or remove the fuse for the circuit where
the oven is installed.
We cannot accept liability for any accident
or incident resulting from non-existent,
defective or incorrect grounding.
If the electrical installation of your
home requires a modification to connect the
appliance, call a qualified electrician.
During maintenance, the appliance must be
disconnected from the mains, the fuses must
be switched off or removed.
600 ext.
560
550 int.
592
18
447
450 int.
547
22
x 2

Table of Contents

Other manuals for Franke Crystal

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Franke Crystal and is the answer not in the manual?

Franke Crystal Specifications

General IconGeneral
BrandFranke
ModelCrystal
CategoryMicrowave Oven
LanguageEnglish

Related product manuals