FMW 45 CR C XS / FMW 45 CR C BK
– 14 –
EN
Cooking guide function
The Cooking guide function selects the
appropriate cooking parameters according to
the food to be prepared and its weight.
Select . You must choose a
preprogrammed food from the following
list:
P01
Ready-to-cook frozen food
P02
Ready-to-cook chilled food (combined function)
P03
Frozen pizza (combined function)
P04
Frozen pizza (traditional cooking)
P05
Fresh pizza
P06
Quiche
P07
Savoury tart
P08
Poultry
P09
Beef
P10
Pork
P11
Ready-to-cook chilled food (microwave)
P12
Fish
P13
Fresh fibrous vegetables
P14
Fresh vegetables
P15
Frozen vegetables
Select the function with
Choose your food with and
Press to confirm.
Depending on the food selected, a
weight (or a cooking time) is suggested
and flashes on the screen.
Modify the required setting with
and
Press to confirm.
Note: Duration cannot be modified for P06
and P07.
By pressing , you access the cooking
end time setting (delayed start ).
Modify it if required with and
Press to confirm.
The oven starts.
Automatic defrost functions
The automatic defrost functions select the
appropriate cooking parameters according to
the food to be prepared and its weight.
Select a pre-programmed food from the list
below:
P01
Defrosting meat, poultry and ready-to-cook dishes
P02
Defrosting fish
P03
Defrosting bread
Select the automatic defrost function
Select a programme and enter the weight
of the food with and (in 50g steps).
Press to confirm.
The delayed start cannot be used with
these positions.
Memory function
The memory function allows you to store 3
common cooking (or defrosting) programs,
which you can then use thanks to quick
selection.
Programming a memory key
First programme a cooking mode of your
choice with
(e.g. fan).
Adjust the temperature and the power
(e.g.: 220°C) and then the cooking time
(e.g.: 25 minutes).
Save your cooking program by holding
down the OK button until MEMO -1- flashes
in the display.
Select one of the available memory
programs: 1 – 2 or 3 with and to go
from one to the next.
Press to confirm.
A beep will confirm that the
programme has been saved.
Using a memory programme
Select the function with
MEMO will appear in the display.
Choose the required MEMO 1 – 2 or 3 with
and to go from one to the next.
Press to confirm.
The programmed memory will be
displayed.
Press the button again; the oven
will turn on and the program will start.
Note: Follow the same procedure to replace
the previous programming. You can store all
functions except automatic programs.
To Next Page
Loading...
