Franke CT-200 - MAINTENANCE AND TROUBLESHOOTING; Disconnecting and Storage Procedures; Reconnecting the Chiller; Common Chiller Problems and Solutions

10
CT-200
Under Sink Chiller Unit Installation Instructions and Use and Care Guide
TROUBLESHOOTING
Problem
Water is not cold.
Cold water drips or sputters from spout.
Water does not flow from spout.
Unpleasant taste.
Check the Following
- Check that the circuit breaker has not tripped or the house fuse
has not blown.
- Check that power supply cord is plugged into electrical outlet.
- Check if the electrical outlet is operated by a switch.
The switch may have turned the power off.
- Cold water in tank is still being chilled. Wait 15 minutes and
check temperature again.
- Check that the Temperature Control is set to the “Max” setting.
- Check that tubing is not bent or kinked.
- Make sure main supply valve is open.
- Check that water pressure to the chiller is 30 psi (138 kPa)
minimum.
- Check to see if chiller is attached to hot water line. If so, attach to
cold water line.
- Check filters for proper installation.
- If the dispenser has not been used for 3 or more days or if only 1
to 3 cups of water are dispensed in a day, the tank may need to be
purged. Open the faucet for 2 to 3 minutes to purge the old water
from the tank. Allow new water in tank to reach desired
temperature (approximately 1 hour) before dispensing water.
- Check to see if filtration element in filtration system needs to be
replaced
MAINTENANCE
DISCONNECTING AND STORAGE
1. Unplug the chiller.
2. Shut off water supply to chiller.
3. Open faucet to release pressure.
4. Disconnect the water lines attached to the chiller by depressing collet on push fittings.
5. Tip chiller to the left side (power cord side) and drain water into a large container.
6. Set chiller in its normal upright position for storage.
RECONNECTING THE CHILLER
1. Shut off water supply to chiller.
2. Put chiller back in position, allowing a 2" (5 cm) space around the side and top.
3. Connect chiller as described in the “Installation Instructions” section.
4. Slowly open main water supply valve and open faucet until water flows.
5. Plug in chiller and set dial to desired water temperature (See the “Setting the Temperature” section).