Franke CT-200 - CONNECTING TO DISPENSING FAUCETS; Faucet Model Specific Connections

Option 3:
For DW13050 dispensing faucet models:
Connect the 1/4" tubing (3) from the chiller (1)
directly to the cold water inlet of the dispensing
faucet (4).
7
12.
13.
4.
3.
15.
1.
Option 1:
For DW50XX, DW61XX, DW70XX, DW80XX,
and DW90XX dispensing faucet models:
Connect the 1/4" tubing (3) from the chiller to
a 3/8" to 1/4" reducer push fitting (13) and
use the black 3/8" tubing supplied with the
dispensing faucet (12) to connect the dispensing
faucet (4) to the 3/8" side of the reducer push
fitting (13).
Option 2:
For DW100XX, DW110XX, and DW120XX
dispensing faucet models:
Slide the compression nut (20) and plastic ferrule
(19) and onto the 1/4" tubing (3) from the chiller
(1). Slide the plastic insert (18) into the end of
the 1/4" tubing from the chiller. Insert the tubing
with compression fitting hardware attached into
the mounting nipple (17) of the faucet (4) and
tighten the compression nut (20).
4.
3.
15.
1.
17.
18.
19.
20.
3.
4.
3.
15.
1.
CT-200
Under Sink Chiller Unit Installation Instructions and Use and Care Guide
6. Connect the 1/4" tubing (3) from the “water out” tee push fitting (2) from the chiller (1) to
the faucet (4). This step will vary, based on dispensing faucet being connected. Identify the
faucet you are connecting and follow the appropriate instruction:
2.