- In order to set the correct time, press the button first, then + or - button to carry forward or backward the figure until the exact
time shows.
Manual operation setting
Press the button to remove the flashing of “AUTO”.
If “AUTO”is flashing (automatic or semi automatic program has been set),press button to remove“AUTO”and then the manual
operation process is on.
Automatic setting (set the time of full automatic starting and ending)
1.Press button, set roast time;
2.Press button, set roast finish
time;
3
.Set temperatures and roast modes by turning the thermostat knob and selector knob.
After the above setting, “AUTO”will be glittering, which means the roast process of the oven is set.
For example: if roast time takes 45 minutes and expect it will end at 14:00.
Press, the roast time is to be 45 minutes;
Press, the roast is set to end at 14:00.
After the above setting, the screen shows the real time(hour、minute)and flashing“AUTO”,it means the set roast process is memorized
automatically
.
When
the clock turns to be 13:15(or between 13:14-13:15), the oven will start automatically.
In the roast time, and“AUTO”will be always flashing.
When the clock turns to be 14, the roast has been finished automatically. The alarm will ring and“AUTO” will flash, press the button
and the ringing will stop.
Semi-automatic setting (set the time of automatic starting and ending
)
A. Set
the time limit of roast (10 hours maximum):
Press the button to set the time of roast;
The oven starts immediately, and“AUTO”will flash. After the roast is finished, the roast operation process will be shut automatically.
Then“AUTO”flashes, the alarm rings. The ringing will stop after the button is pr
essed.
B
. Set the time of ending (23 hours 59 minut
es maximum):
P
ress the button to set the time of ending;
The oven starts immediately, and“AUTO”will flash. When the set time of ending is reached, the roast process will shut automatically.
Then“AUTO”flashes, the alarm rings. The ringing will stop after the button is pr
essed.
When the re
lated button is pressed, the set roast process will be displayed. Whenever the button is pressed, and set backward the
time to “0”,the set roast process will be cancelled. When button is pressed again, the oven will revert to the manual operation
process.
Time
r
2
3 hours 59 minutes can be set as ma
ximum.
T
o set the time, press the button, and then + or - button, until the required time is shown on the screen. After the setting, the correct
time (hour, minute) and the button will show on the screen. When the button is pressed the time displaced will be seen. When the
set time is reached, disappears and the alarm will ring again. To stop the alarm, press the button.
Notice:
After pressing the related button, setting is supposed to be done in 5 seconds. In case of blackout, the set process as well as the
To Next Page
Loading...
Need help?
General