Installation and connection
1. This appliance has been designed exclusively
for domestic use.
2. The oven in question has been designed as an integrated appliance.
3. Observe the special installation instructions.
4. The appliance can be installed in a wall-mounted cupboard in heat-resistant material, with a
width of 60 cm (at least 85 cm from the floor).
5. The appliance is fitted with a plug and simply needs to be connected to a suitably installed
socket, which in turn must be earthed.
6. The mains voltage must correspond to the voltage specified on the appliance rating plate.
7. Socket installation and power cord replacement procedures must be carried out exclusively by a
specialised electrician. If, after installation, the plug is no longer accessible, fit an omnipolar
disconnect switch with a contact opening gap of at least 3 mm in accordance with the wiring rules.
8. Use of adapters, multi-socket power strips and extension cables is prohibited. Any current
overloads could, in fact, cause a fire.
Accessible surfaces can
become very hot during use.
a
a
CENTER LINE
FRONT EDGE
LEFT EDGE
RIGHT EDGE
C x 10
1
0
To Next Page
Loading...
