– 17 –
CM FS 45 BK
EN
Changing the quantity of milk and coffee for
cappuccino or latte macchiato
The appliance is set by default to automatically
deliver a standard cappuccino or latte macchiato.
To change these quantities, proceed as follows:
Fill the container with milk up to the maximum level.
Hold the touch key (12) until the message
MILK FOR CAPPUCCINO PROGRAM QUANTITY
is displayed or hold the (13) touch key until
the message MILK FOR MACCHIATO PROGRAM
QUANTITY is displayed.
Release the touch key. The appliance starts
delivering milk.
Once the required quantity of milk has been delivered
into the cup, press the touch key (12) or (13)
touch key again. After a few seconds, the appliance
starts delivering coffee into the cup and the message
COFFEE FOR CAPPUCC. PROGRAM QUANTITY or
COFFEE FOR MACCHIATO PROGRAM QUANTITY is
displayed.
Once the required quantity of coffee has been
delivered into the cup, press the touch key (12)
or (13) touch key again. Coffee delivery stops.
The machine is now reprogrammed with the new
milk and coffee quantities.
Cleaning the spouts
Clean the spouts on the milk container every time
after heating milk or making cappuccino. Otherwise,
remains of milk may set hard.
Place a container under the milk
dispenser pipe and press on the
CLEAN button (N3) on the milk
container for at least 5 seconds.
The display shows CLEANING!
Risk of scalding from steam and hot water
escaping from the milk dispenser pipe.
Remove the milk container and clean the spouts
on the appliance with a damp cloth.
Put the hot water spout back in.
Note: After you finished cleaning, remove the milk
container and place it in the fridge, as the milk should
not stay out of the fridge for longer than 15 minutes.
See “Cleaning the spouts and the milk container” for
information on cleaning the milk container.
To Next Page
Loading...
Need help?
General
